February 24, 2020
Posted by: Swenson Shear
How to Adjust a Standing Seam Slitter on the SnapTable PRO®
The panel cutter on the SnapTable PRO may be adjusted to accommodate any metal panel thickness. While roofing contractors typically work with metal ranging from 24 to 26 gauge, the Panel Cutter on the SnapTable PRO may be adjusted to accommodate metal panels as thick as 20 gauge. Depending on gauge thickness, the slitter blade may be lowered or raised up.
Swenson Shear Standing Seam Slitter
Luckily, making this adjustment on your SnapTable PRO is, well, a snap! Watch the video below for step-by-step instructions for how to adjust your standing seam slitter blade on the SnapTable PRO:
- Loosen the lock bolt on the slitter using a 9/16 wrench.
- Loosen the nut between the aluminum post and the steel frame.
- Depending on the depth of the blade, loosen the bolt to tighten the nut or vice versa.
- Repeat steps 1-3 on the opposite side of the slitter.
- Once the appropriate adjustments have been made, be sure to tighten the lock bolt on both sides prior to using the slitter.
Learn More About Swenson Shear’s Panel Cutter
Swenson Shear’s dual-edged Panel Cutter makes cutting through standing seam metal roof panels simple and easy — while also producing consistent, factory-like cuts free of burrs. These roofing tools offer a max cutting length of 60 inches and can be rotated 360 degrees for optimal usability. While the Panel Cutter can be purchased individually, it is also available as part of the SnapTable PRO, an all-in-one standing seam panel preparation system by Swenson Shear that can cut, notch, and hem panels in mere seconds. Founded in 1959 and based in Ceres, CA, Swenson Shear is the #1 international provider of metal roof cutting tools for standing seam roofs, exposed fastener roofs, and stone coat roofs. To request a quote for the Panel Cutter or our towable SnapTable PRO, contact [email protected] or call (877) 588-8748.
Contact